Pro Micro ATmega32U4 5V 16MHz Arduino Clone
This tiny board does all of the Arduino tricks that you're familiar with: 4 channels of 10-bit ADC, 5 PWM pins, 12 DIOs as well as hardware serial connections Rx and Tx. Can be programmed for an HID device. Running at 16MHz and 5V, this board will remind you a lot of your other favorite Arduino-compatible boards. There is a voltage regulator on board so it can accept voltage up to 12VDC. If you're supplying unregulated power to the board, be sure to connect to the "RAW" pin on not VCC.
Features:
ATMega 32U4 running at 5V/16MHz
Supported under Arduino IDE v1.0.1
On-Board micro-USB connector for programming
4 x 10-bit ADC pins
12 x Digital I/Os (5 are PWM capable)
Rx and Tx Hardware Serial Connections
Package:
1 X New Pro Micro ATmega32U4 5V 16MHz Module
This tiny board does all of the Arduino tricks that you're familiar with: 4 channels of 10-bit ADC, 5 PWM pins, 12 DIOs as well as hardware serial connections Rx and Tx. Can be programmed for an HID device. Running at 16MHz and 5V, this board will remind you a lot of your other favorite Arduino-compatible boards. There is a voltage regulator on board so it can accept voltage up to 12VDC. If you're supplying unregulated power to the board, be sure to connect to the "RAW" pin on not VCC.
Features:
ATMega 32U4 running at 5V/16MHz
Supported under Arduino IDE v1.0.1
On-Board micro-USB connector for programming
4 x 10-bit ADC pins
12 x Digital I/Os (5 are PWM capable)
Rx and Tx Hardware Serial Connections
Package:
1 X New Pro Micro ATmega32U4 5V 16MHz Module
This tiny board does all of the Arduino tricks that you're familiar with: 4 channels of 10-bit ADC, 5 PWM pins, 12 DIOs as well as hardware serial connections Rx and Tx. Can be programmed for an HID device. Running at 16MHz and 5V, this board will remind you a lot of your other favorite Arduino-compatible boards. There is a voltage regulator on board so it can accept voltage up to 12VDC. If you're supplying unregulated power to the board, be sure to connect to the "RAW" pin on not VCC.
Features:
ATMega 32U4 running at 5V/16MHz
Supported under Arduino IDE v1.0.1
On-Board micro-USB connector for programming
4 x 10-bit ADC pins
12 x Digital I/Os (5 are PWM capable)
Rx and Tx Hardware Serial Connections
Package:
1 X New Pro Micro ATmega32U4 5V 16MHz Module